Skip to main content

Week 11 (04-11-18): Presentation 2

This week, I am finally back from Los Angeles. I worked on this presentation when I was there and we met on Monday to hash out some of the logistical issues for the delivery of Presentation 2. Angelo was going to start off this time to talk about the design requirements and specifications, I spoke about the manufacturing progress and the dependencies and contingencies, while Kevin spoke about the Gannt Chart and the current budgeting status for our team.




By the end of this week, I was supposed to weld the components that Kevin prepared last week, however, we ran into some issues when the tank of Argon ran out for the welder. Luckily, I was only working on the first test piece, however, due to the lack of gas, the welds that I made became defective and created rust on the components. Kevin and I will get more information from administration to make sure we know what to do for the next steps.

Comments

Post a Comment

Popular posts from this blog

Week 14 (05-02-18): Finishing up the Supports & Putting the Track Together

Last week, I ground down the welded support parts that attach to the track. I finished 20 of these parts and it required a lot of patience since grinding down steel requires some time. I even had a collet for the Dremel tool break on me since the diamond tip Dremel-bit pushed the collet to open up throughout the duration of the grinding process. By trying to close up the collet to secure the bit, one of the collet's prongs broke. After these parts were completed, I started drilling holes into them to ensure that they would fit into the whole track assembly smoothly. I used the drill press and some of the brackets that Kevin finished printing. The end result of these components looks like the following image: After the support structures were put together, we assembled the track fully for the first time. Although it was a small assembly that reduced the length of the track, due to removing several straights, it allowed for the other subteams to test the bogey and controls....
Post a Comment
Read more

Week 15 (05-09-18): Final Presentation

This week, we gathered at the Student Union to finish up the last presentation of the semester. We met up several times to ensure that our last presentation had the proper flow and clarity so that anyone who hasn't encountered Spartan Superway will know the scope of our project. Most of the time was spent ensuring that all of the work we did this semester was covered comprehensively. We even included a master slide system and an appendix section for all of the miscellaneous FEA Analysis and manufacturing questions that members of the crowd might ask. The last presentation of the Spartan Superway Track Design and Manufacturing team is shown below: Now it's time to get ready for Maker Faire!
Post a Comment
Read more

Week 13 (04-25-18): Cleaning up Welded Track Attachments

This week, I focused my efforts on cleaning up some of the welded sections that I worked on last week. Within the square tubing, there is a slight rise that follows along the length of the tubing. This makes it impossible for these parts to slide into the support sleeves that we have already made. In order to finish up these components, I filed them down with a combination of using a Dremel tool with a diamond bit tip and Spartan Superway's file. The first image shows the excess metal that protrudes out of the inside of the square tubing. The next image shows that same protrusion grinded down with the use of the Dremel tool and shop file.
Post a Comment
Read more